 |
|
|
| P.O. Box 500, Bristol, New Hampshire 03222 ♦ 603-744-6400 ♦ fax 603-744-3700 |
|
|
French Translation (PDF) |
Portuguese Translation (PDF) |
Spanish Translation (PDF)
|
| |
|
|
JPS Customized Tank Baffles are today's ideal choice for precise transit-time control in chlorine contact chambers, to help ensure compliance with EPA regulations. Constructed of tough, long-lasting XR-5 and sewn with a special chlorine-resistant thread, JPS Baffles are FDA and NSF approved.
The Customized Tank Baffles are manufactured to your facility's dimensions in our plant, and delivered to you as a complete kit, including all the required stainless steel hardware. You can install the baffles yourself under the supervision of our
representative, or we will install the unit.
JPS can fabricate Customized Tank Baffles to meet virtually any imaginable
application. Constructed by hand, using the same patented materials that have earned JPS products a worldwide reputation for quality and durability, these Customized Tank Baffles offer several advantages in today's time- and cost-driven environment:
- JPS Customized Tank Baffles cost about one tenth (conservatively estimated) of traditional "hard" construction.
|
- JPS Customized Tank Baffles save valuable time; we take all the required measurements, manufacture the baffles in our plant, and deliver a complete finished kit that we can install without a prolonged shut-down of your facility.
- JPS Customized Tank Baffles are, unlike "hard" construction, in most cases infinitely adjustable after installation; in-field flow modifications to refine treatment processes can be done quickly and economically; the baffles can be easily altered as needed.
- All JPS Baffles carry our standard two-year, 100% warranty.
|
|
|
A Scrim
Nylon, with rip stops every fourth filament.
B Auxiliary Ballast and Bottom Seal
Continuous 5/16" galvanized chain, sealed into bottom pocket with hand stitching.
C Stitching
Silicon-treated nylon, lock-stitched, sewn by hand.
E Grommets
#304 stainless steel, at 12-inch intervals at end of each 50-foot section.
F Nuts, Bolts and Washers
#304 stainless steel, to connect sections.
Floats
External, blow-molded polypropylene with UV inhibitor, on both sides of curtain or boom between support rods. Attached with a composite compressor toggle.
Skirt
Flexible, depth depending upon need.
Top and Bottom Straps
12,000-lb tensile strength nylon, hand-sewn.
Side Straps
20,000-lb tensile strength nylon, hand-sewn.
Cross-weave Design
12,000-lb tensile strength nylon, hand-sewn every
5-feet in the vertical, and every 5-feet in the horizontal.
Cross weave design can be increased in situations where extreme stresses are involed.
|
|
|
| |
|
|
|
